ADVA

Connect a LAN Cable to the MGMT LAN port and connect the other end of the cable
to your networking gear (PC, hub, switch, or router). From the factory, the default IP
address of the FSP 150CCf-825 is: 192.168.0.2/24.

Connect serial cable to port, usual speeds, 8N1, 9600.
Hit the “Enter” key and you will be prompted to enter a login and password. The
default login and password are ‘covaro1’ and ‘covaro#1,’ respectively. A warning
banner and continue query displays. Enter “y” to the query and the serial console CLI
prompt (–>) will then be displayed.

Not tested at this time.

Procedure to reset your device to Factory Defaults.
After you return to the defaults, login as
Login : Root
Pass: ChgMeNOW

Procedure to recover default password sent:

1. Connect to the serial port using an Ethernet straight through cat-5 and the FSP 150CC RJ-45 to DB9 adapter. 
2. Open an application that allows you to connect to your serial port and specify the following attributes:
• Bits per Second: 9600
• Data Bits: 8
• Parity: None
• Stop Bits: 1
• Flow Control: None
3. Cycle the power to the FSP 150 CC and immediately depress the space bar on the serial port application until you see the following prompt:

Key pressed, stopping boot.

Entered console ... User request.
  
Type 'help' to list available commands.

4. At the prompt, hit return once to get past any space characters that were accepted. Then enter the defaultdb command and reset the unit:

defaultdb
Restoring factory defaults... done.
reset

Settings for serial port are 57600 8N1, bit unusual. The serial port is presented on a USB mini connector, rather than a 9Pin “D”, so you will need a USB cable. This presents as /dev/ttyUSB0 on my laptop.

Pressing space during boot interrupts boot and shows the following menu:-

=> help
?       - alias for 'help'
boot    - boot the system
help    - print command description/usage
mtest   - simple RAM read/write test
phyinv  - displays the contents of physical inventory
reboot  - reset the system
version - print monitor, compiler and linker version
=>

defaultdb from above doesn't seem to work.