This WIC card supports 3G radio and GPS location. It seems to be based round a laptop style GSM / GPS module.
Using gsm/gps module as a fpga:- https://hackaday.io/project/168542-cisco-hwic-3g-cdma-as-a-cheap-fpga-board/log/171121-reverse-engineering-the-cisco-hwic-3g-cdma
backup cellular routing
http://wiki.ciscolinux.co.uk/index.php?title=Cisco_1941_with_EHWIC-3G-HSPA%2B7_card_configuration
https://bayupw.blogspot.com/2008/05/configuring-cisco-hwic-3g.html
This is for UK Orange / EE:-
Router#$0/0 gsm profile create 3 everywhere chap eesecure secure ipv4 Profile 3 will be created with the following values: PDP type = IPv4 APN = everywhere Authentication = CHAP Username = eesecure Password = secure Are you sure? [confirm] Profile 3 written to modem Router#
Router#show cellular 0/0/0 network Current Service Status = Emergency Only, Service Error = None Current Service = Invalid Packet Service = None Packet Session Status = Inactive Current Roaming Status = Home Network Selection Mode = Automatic Country = GBR, Network = O2 - UK Mobile Country Code (MCC) = 234 Mobile Network Code (MNC) = 10 Location Area Code (LAC) = 21565 Routing Area Code (RAC) = 146 Cell ID = 26948 Primary Scrambling Code = 0 PLMN Selection = Automatic Router#
Need to fix
No physical hardware support for line 8
modem InOut
^
% Invalid input detected at '^' marker.
no exec
^
% Invalid input detected at '^' marker.
transport input all
^
% Invalid input detected at '^' marker.
transport output all
^
% Invalid input detected at '^' marker.
stopbits 1
^
% Invalid input detected at '^' marker.
speed 4800
^
% Invalid input detected at '^' marker.
Configure module to use NMEA sentences, The GPS antenna has to connect to the GSM diversity TNC connector, so you cannot use the GSM diversity at the same time as GPS.
On the EHWIC card, there is a green LED for status, it can be used for troubleshooting. It will be off while searching and illuminate solid green once a GPS fix is obtained.
Config:-
1901-1(config)# controller cellular 0/0/0 1901-1(config-controller)# gsm gps mode standalone 1901-1(config-controller)# gsm gps nmea 1901-1(config-controller)# exit
Status and monitoring:-
1901-1#sh cellular 0/0/0 gps detail GPS Info ------------- GPS Status: GPS acquiring GPS Mode Configured: standalone Latitude: 0 Deg 0 Min 0 Sec North Longitude: 0 Deg 0 Min 0 Sec East Timestamp (GMT): Sun Jan 6 00:00:00 1980 Fix type index: 0 HEPE: 0 cm, GPS Mode Used: not configured/unknown, Positioning Source index invalid: 0 Uncertainty Info: Angle: 0 deg, A: 50 cm, Position: 50 cm, Vertical: 50 cm Satellite Info ---------------- 1901-1#