Rainsbrook

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Upgrade for LAP1260N-E-K9 Access point and config ======


Not much done on this for various reasons, I have upgraded to a [[ruckus7363accesspoint|Ruckus 7363 Access Point]] instead for now.

===== Introduction =====

Cisco's 1260 wireless access point can be run in two modes, the most common seems to be in LAP or lightweight mode, this requires a wireless controller to function, or the other mode is Autonomous which means it runs as a stand alone Access point without any dependancy on other devices.

The LAP can be converted to Autonomous mode by reflashing IOS with a different image.

This page covers upgrading a Lightweight (LAP) 1260 Access point to autonomous mode. This means it will function independent of any Wireless Controller. 

It will also cover setting up multiple SSIDs with a trunk uplink to the switch.


{{networking:cisco-air-lap1262n-a-k9-aironet-1262n-80211n-wireless-access.jpg?200 |}}
{{networking:cisco-air-cap2602i-e-k9-v02-80211n-poe-wi-fi-access-point.jpg?200 |}}


----


This link from Cisco covers config for Personal and Enterprise use:- [[https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/67134-wpa2-config.html]]


===== Diagram =====


Hint:- Use https://www.draw.io/. for block diagram of ios and bridge groups 




----

This page has been accessed:- \\
Today: {{counter|today}} \\
Yesterday: {{counter|yesterday}} \\
Until now: {{counter|total}} \\