Rainsbrook

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== 1200 WiFi Access Point WPA & WPA2 config ======


After a ''write erase'' and ''reload'', the Default Credentials are:-

    Username: Cisco
    Password: Cisco 


  AP1200#show run
  Building configuration...
  
  Current configuration : 2183 bytes
  !
  ! No configuration change since last restart
  !
  version 12.3
  no service pad
  service timestamps debug datetime msec
  service timestamps log datetime msec
  service password-encryption
  !
  hostname AP1200
  !
  enable secret 5 $1$X86e$WcSzzzvccccccxxxxxhkSNcD.
  !
  ip subnet-zero
  ip domain name rainsbrook.co.uk
  ip name-server x.x.x.x
  !
  !
  no aaa new-model
  dot11 vlan-name default vlan 1
  !
  vlan 1
    authentication open 
    authentication key-management wpa
    guest-mode
    wpa-psk ascii 7 096E1A0713adasdasdasd
  !
  !
  !
  username Cisco password 7 04zzasdasasdasd
  username admin privilege 15 password 7 045zzssxxasdasdasd
  !
  bridge irb
  !
  
WPA uses ''encryption vlan 1 mode ciphers tkip'', WPA2 uses ''encryption vlan 1 mode ciphers aes''.

  !
  interface Dot11Radio0
   no ip address
   no ip route-cache
   !
   encryption vlan 1 mode ciphers tkip 
   !
   ssid <my-ssis>
   !
   speed basic-1.0 basic-2.0 basic-5.5 basic-6.0 basic-9.0 basic-11.0 basic-12.0 basic-18.0 basic-24.0 basic-36.0 basic0
   channel 2472
   station-role root access-point
   no dot11 extension aironet
  !
  interface Dot11Radio0.1
   encapsulation dot1Q 1 native
   no ip route-cache
   bridge-group 1
   bridge-group 1 subscriber-loop-control
   bridge-group 1 block-unknown-source
   no bridge-group 1 source-learning
   no bridge-group 1 unicast-flooding
   bridge-group 1 spanning-disabled
  !
  interface FastEthernet0
   no ip address
   no ip route-cache
   duplex auto
   speed auto
  !
  interface FastEthernet0.1
   encapsulation dot1Q 1 native
   no ip route-cache
   bridge-group 1
   no bridge-group 1 source-learning
   bridge-group 1 spanning-disabled
  !
  interface BVI1
   ip address w.x.y.z 255.255.255.0
   no ip route-cache 
  !
  ip default-gateway a.b.c.d
  no ip http server
  no ip http secure-server
  ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag
  !
  snmp-server community topsecret RO
  snmp-server location GuessWhere
  snmp-server contact wwwxxx@rainsbrook.co.uk
  snmp-server chassis-id ap1200
  !
  control-plane
  !
  bridge 1 route ip
  !         
  !
  !
  line con 0
   transport preferred all
   transport output all
  line vty 0 4
   login local
   transport preferred all
   transport input all
   transport output all
  line vty 5 15
   login
   transport preferred all
   transport input all
   transport output all
  !
  sntp server w.x.y.z
  sntp broadcast client
  end