rb:sfp
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| rb:sfp [31/01/2025 18:01] – [WDM Fibre] andrew | rb:sfp [26/09/2025 10:07] (current) – [SFP module (Small Form-factor Pluggable)] andrew | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== SFP module (Small Form-factor Pluggable) ====== | ====== SFP module (Small Form-factor Pluggable) ====== | ||
| - | SFP modules followed on from [[rb: | + | SFP modules followed on from [[rb: |
| + | |||
| + | SFP used for Fibre channel can be 1 or 2GB/s but most common is 4GB/s. | ||
| Line 27: | Line 29: | ||
| ===== WDM Fibre ===== | ===== WDM Fibre ===== | ||
| - | {{:rb: | + | {{ rb: |
| + | {{rb: | ||
| Another option is Wavelength Division Multiplex SFP which use two different wavelength for Tx and Rx, so only needing one fibre. This example uses SC single mode ( SC == Stick ' | Another option is Wavelength Division Multiplex SFP which use two different wavelength for Tx and Rx, so only needing one fibre. This example uses SC single mode ( SC == Stick ' | ||
| - | {{ rb:img_20250129_181046.jpg?200|}} | + | |
| + | ---- | ||
| + | |||
| + | {{ : | ||
| + | ---- | ||
| + | |||
| + | |||
| + | |||
| + | {{: | ||
| + | As this used two wavelengths, | ||
| + | |||
| + | ---- | ||
| + | |||
| + | {{: | ||
| + | I'm guessing here, but I believe the laser is mounted at the rear with the 3 pins connection to the PCB, and the RX connections are on the side with flexible connection to the PCB. | ||
| + | {{ rb: | ||
| + | |||
| + | ---- | ||
| + | |||
| + | {{: | ||
| + | Close-up of the Prism housing and SC receptacle. | ||
| + | |||
| + | |||
| + | |||
| + | ---- | ||
| + | ===== Multimode Fibre ===== | ||
| + | |||
| + | {{: | ||
| + | |||
| + | |||
| + | {{:rb:sfp_152240.jpg?200 |}} | ||
rb/sfp.1738346477.txt.gz · Last modified: by andrew
