User Tools

Site Tools


networking:fvcaccessngi

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
networking:fvcaccessngi [26/07/2025 18:01] – [Background] andrewnetworking:fvcaccessngi [26/07/2025 18:02] (current) andrew
Line 11: Line 11:
 It supports both SVCs and PVCs. The basic switch has an ethernet port on the control module next to the RJ45 console connection. This is not the same pinout as Cisco use. The ethernet port interfaces to the atm network using Lan Emulation. An alternative module can supply 6 ethernet ports. All the ports in this module are on the same ELAN, the choice of ELAN is made at the vether modue level. All the ethernet ports are 10MB/s. It supports both SVCs and PVCs. The basic switch has an ethernet port on the control module next to the RJ45 console connection. This is not the same pinout as Cisco use. The ethernet port interfaces to the atm network using Lan Emulation. An alternative module can supply 6 ethernet ports. All the ports in this module are on the same ELAN, the choice of ELAN is made at the vether modue level. All the ethernet ports are 10MB/s.
  
-I was told that the firmware running is FORE's ForeThought, so some of the commands are similar to [[foremarconi|Fore Marconi ATM]] Switch.+I was told that the firmware running is FORE's ForeThought, so some of the commands are similar to [[config-asx200bx|ASX200BX Config and info]].
  
 The built in ethernet port uses LAN Emulation to bridge to atm, but seems unable to terminate an rfc1483 pvc. We used to use them as an access switch on the end of a 2MB/s G703 leased line, the ethernet port linked in to an ethernet switch, and the 25MB/s ports is used for a few pc's which need to connect to different networks. The built in ethernet port uses LAN Emulation to bridge to atm, but seems unable to terminate an rfc1483 pvc. We used to use them as an access switch on the end of a 2MB/s G703 leased line, the ethernet port linked in to an ethernet switch, and the 25MB/s ports is used for a few pc's which need to connect to different networks.
networking/fvcaccessngi.txt · Last modified: by andrew

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki