Differences

This shows you the differences between two versions of the page.

--- networking:cisco7206 [25/07/2025 22:18] – andrew
+++ networking:cisco7206 [30/12/2025 11:49] (current) – [ATM] andrew
@@ Line 5: / Line 5: @@
 ===== General router config =====
-Lets set a password and a hostname. Without a password, the router will not allow any network based access. This sets up a password on telnet (vty) and the console serial port (con). Additionally and enable secret is set to allow higher level of access for configuration.
+Lets set a password and a hostname. Without a password, the router will not allow any network based access. This sets up a password on telnet (vty) and the console serial port (con). Additionally an enable secret is set to allow higher level of access for configuration.
 <code>
@@ Line 80: / Line 80: @@
 cisco7206#
 </code>
+[[https://archive.org/download/cIOS-firmware-images/]]
@@ Line 139: / Line 141: @@
-Test circuit on the Cisco router. This uses a [[ibm8265|IBM PVC]] (or this [[config-asx200bx#pvc_setup|Marconi PVC]]) which you will have to set up om the ATM switch. I believe the Cisco card supports being a LAN emulation client which would usually use a SVC.
+Test circuit on the Cisco router. This uses a [[ibm8265|IBM PVC]] (or this [[config-asx200bx#pvc_setup|Marconi PVC]]) which you will have to set up on the ATM switch. I believe the Cisco card supports being a LAN emulation client which would usually use a SVC.
 I want the atm addresses to be entirely different to the ones I use internally, so I will set the router to 172.16.0.1 and the other end, my Ubuntu server machine will have the IP address 172.16.0.2.