Differences

This shows you the differences between two versions of the page.

--- networking:cisco-2801-gsm-gps [30/12/2025 14:47] – andrew
+++ networking:cisco-2801-gsm-gps [27/01/2026 14:35] (current) – [Cisco 3g hwic gps] andrew
@@ Line 1: / Line 1: @@
-====== Cisco 2801 with gsm and gps modules ======
+====== Cisco 2801 with WiFi and gsm / gps modules ======
+===== Boot Failure =====
+rommon1>
+<code>
+Set the configuration register with the confreg command if the router is in ROMmon mode:
+rommon 1 > confreg 0x2102
+</code>
+<code>
+Router#show hardware
+Cisco IOS Software, 2801 Software (C2801-ADVIPSERVICESK9-M), Version 15.1(4)M1, RELEASE SOFTWARE (fc1)
+...edited...
+ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
+Router uptime is 33 minutes
+System returned to ROM by power-on
+System restarted at 11:59:32 UTC Mon Jan 2 2006
+System image file is "flash:c2801-advipservicesk9-mz.151-4.M1.bin"
+Last reload type: Normal Reload
+...edited...
+Cisco 2801 (revision 7.0) with 358400K/34816K bytes of memory.
+Processor board ID FCZ121715KL
+FastEthernet interfaces
+Channelized E1/PRI ports
+Virtual Private Network (VPN) Module
+802.11 Radios
+DRAM configuration is 64 bits wide with parity disabled.
+K bytes of NVRAM.
+K bytes of ATA CompactFlash (Read/Write)
+Configuration register is 0x2102
+Router#
+</code>
+<code>
+Router#configure terminal
+Enter configuration commands, one per line. End with CNTL/Z.
+Router(config)#config-register 0x2102
+Router(config)#end
+</code>
+<code>
+!
+boot-start-marker
+boot system flash:c2801-advipservicesk9-mz.151-4.M1.bin
+boot-end-marker
+!
+</code>
+===== Wifi =====
 AP wifi https://www.cisco.com/c/en/us/td/docs/routers/access/interfaces/ic/hardware/installation/guide/ap_hwic.html
+===== GSM =====
@@ Line 14: / Line 79: @@
 {{:networking:ehwic-gsm.png?400|}}
 ==== Create APN profile ====
@@ Line 105: / Line 171: @@
 [[https://smartvision.solutions/?q=node/25]]
+====== VOIP ======
+<code>
+Router(config)#telephony-service setup
+Warning: <telephony-service setup> command has been deprecated.
+For installation help, please check CME System Administrator Guide.
+Goodbye!
+Router(config)#
+</code>