Differences

This shows you the differences between two versions of the page.

--- networking:cisco-2801-cme [23/04/2026 14:26] – [VOIP] andrew
+++ networking:cisco-2801-cme [23/04/2026 23:33] (current) – [Cisco HWIC-AP] andrew
@@ Line 5: / Line 5: @@
-rommon1>
+System boots to ''rommon1>'' but no further.
 <code>
-Set the configuration register with the confreg command if the router is in ROMmon mode:
+Set the configuration register with the confreg command if the router is in rommon mode:
 rommon 1 > confreg 0x2102
 </code>
+Boot ok, so let's see what's detected.
 <code>
@@ Line 45: / Line 47: @@
 </code>
+Set the config register in IOS:-
 <code>
@@ Line 52: / Line 57: @@
 Router(config)#end
 </code>
+From a ''dir flash:'', get the IOS file name to boot from:-
 <code>
@@ Line 63: / Line 70: @@
+====== Cisco HWIC-AP ======
+{{:undefined:hwic-ap.png?300|}}
+Access point for wifi - very sketchy so far.
-====== Cisco HWIC-AP ======
-{{:undefined:hwic-ap.png?200|}}
-Access point for wifi - UNTESTED!
 [[https://community.cisco.com/t5/wireless/wireless-config-on-2811-with-hwic-access-point/td-p/648658]] - Broadcast of ssid link