Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
rb:cisco-1262-ap-upgrade-config [10/01/2019 15:29]
andrew
rb:cisco-1262-ap-upgrade-config [08/11/2019 15:59] (current)
andrew
Line 1: Line 1:
 ====== Upgrade for LAP1260N-E-K9 Access point and config ====== ====== Upgrade for LAP1260N-E-K9 Access point and config ======
 +
 +===== Introduction =====
 +
 +Cisco'​s 1260 wireless access point can be run in two modes, the most common seems to be in LAP or lightweight mode, this requires a wireless controller to function, or the other mode is Autonomous which means it runs as a stand alone Access point without any dependancy on other devices.
 +
 +The LAP can be converted to Autonomous mode by reflashing IOS with a different image.
  
 This page covers upgrading a Lightweight (LAP) 1260 Access point to autonomous mode. This means it will function independent of any Wireless Controller. ​ This page covers upgrading a Lightweight (LAP) 1260 Access point to autonomous mode. This means it will function independent of any Wireless Controller. ​
  
 It will also cover setting up multiple SSIDs with a trunk uplink to the switch. It will also cover setting up multiple SSIDs with a trunk uplink to the switch.
 +
 +
 +{{:​rb:​cisco-air-lap1262n-a-k9-aironet-1262n-80211n-wireless-access.jpg?​200 |}}
 +{{:​rb:​cisco-air-cap2602i-e-k9-v02-80211n-poe-wi-fi-access-point.jpg?​200 |}}
 +
 +
 +===== Diagram =====
 +
  
 Hint:- Use https://​www.draw.io/​. for block diagram of ios and bridge groups ​ Hint:- Use https://​www.draw.io/​. for block diagram of ios and bridge groups ​

rb/cisco-1262-ap-upgrade-config.txt ยท Last modified: 08/11/2019 15:59 by andrew